欢迎访问

河北程跃泵业有限公司

网站
联系方式
  • 电话:0312-3426976
  • 联系人:徐经理
  • 手机:13932271419
  • 手机2:15030285258
  • 业务QQ:632469545
  • 网站:www.bdcyhgb.com
  • 地址:河北安国市石佛镇路景工业园区景旺路8号

化工泵的安装顺序

date.png 2019-06-11 11:32:52

化工泵装置次第

① 将化工泵机组放在埋有地脚螺栓的根底上,在底座和根底之间放置成对的楔垫作找正之用。

② 松开联轴器。用程度仪分别放在泵轴或底座上,经过调整禊垫,找正机组的程度后,恰当拧紧地脚螺栓,以防走动。

③ 用混凝土灌注底座和地脚螺检孔。

④ 待混凝土干涸后,应拧紧地脚螺栓,^并重新检查泵轴的氷平度。

⑤ 在接好管路及肯定原动机转动方向以后,接上联轴器,再核对一遍轴的同心度,丈量联轴器的外园上下,左右的差别不得超越0.1mm,两联轴器端面间隙,在一周内大和小的间咪差不得超越0.3mm.

⑥ 在化工泵机组实践运转3 — 4小时后作后检查,如无不良现象,则以为装置合格。

Installation order


(1) Place the unit on the base of the anchor bolt, and place a pair of wedge cushions between the base and the base for alignment.


(2) Loosen the coupling. After adjusting the mat and correcting the degree of the unit, tighten the anchor bolt properly to prevent moving.


(3) Inspecting holes with concrete grouting base and foot snail.


After the concrete dries up, the anchor bolt should be tightened, and the flatness of the pump shaft should be re-checked.


_After connecting the pipeline and confirming the rotation direction of the prime mover, connect the coupling, check the concentricity of the shaft again, measure the difference between the outer circle and the upper circle of the coupling, and the difference between the left and right should not exceed 0.1 mm. The gap between the ends of the two coupling should not exceed 0.3 mm in a week.


_After 3-4 hours of unit operation, final inspection shall be made. If there are no adverse phenomena, the device shall be considered qualified.


联系方式

ico04
联系人

徐经理

ico01
电话

0312-3426976

ico06
手机

13932271419

ico05
QQ

632469545

ico03
邮箱

632469545@qq.com

ico02
地址

河北安国市石佛镇路景工业园区景旺路8号

 
<
线

商盟客服 >
您好,欢迎莅临我们的网站,欢迎咨询...

  • 徐经理: 点击这里给我发消息